Do some 3D Modelling

Complete the vise assembly using the parts created in previous homework assignments. if parts were not created, create all project parts as shown in Lessons 3, 4, 5, 6, 7, 8, and 9. Follow the instructions on page 10-30. Note the cut-away and exploded view are not separate models. I should be able to review the section and exploded view from within the completed vise assembly. Move the exploded view components, if necessary, so they appear in an order of assembly that makes sense. For example, the base component in the picture on page 10-31 would look better if placed above the flat plate and below the spherical halves. Packaged components are parts that are not fully assembled. This occurs when all of the constraints to control all degrees of freedom are not satisfied. A packaged model is identified by an open block in the lower left corner of the part icon in the model tree. You can tell if the model is fully constrained by looking at the Status area in the Placement tab when assembling a component. No packaged components are allowed for this assembly. This is an individual project. All models submitted, vise assembly and components, shall be your own. Submit the assembly model and all component parts used in the assembly. These models can be uploaded as single files or as a single compressed zip file. Remember that uploading the assembly only will not also upload the parts used in the assembly. The assembly model only contains information on how to assemble the components and does not contain the part information. Review the rubric for grading requirements.