Hello,
I have 10+ years of Experience in Embedded HW product design with multiple domains like a consumer, industrial, automotive, IoT, and wearable products.
-Hardware architecture design using MCU, controller, and FPGA, as well as low power battery, operated device
-Experience in all phases of product development from prototyping to mass production
-Experience in Schematic design and high-speed PCB layout board design with multilayer PCB design, Blind & Buried Vias in HDI Design.
-Working experience on power management system design with Buck-boost, Battery charger, and fuel gauge, USB3.0 Ctype and PD charging, POE and etc
-Expertise in design and simulation of analog circuits,
-Experience in Microprocessor and microcontrollers like NXP, ST, Microchip, Marwell, Qualcomm, MediaTek, TI, Renesas, and Atmel
-Exposure in mechanical design review
-Expertise in wireless SOC with Bluetooth, WIFI, 4G, Lora, Zigbee from NXP, Nordic, Ublox, Qualcomm, Cypress, Broadcomm, TI, ESP, Silabs, Microchip
-Experience in wire interface USB2/3, SPI, I2C, UART, HDMI, Ethernet, SDIO, MIPI-CSI/DSI, CAN, Modbus, RS232, RS485
-EMI / EMC compliance testing and product certification like CE/FCC/UL and etc
-Expertise in hardware testing and troubleshooting/root cause
Also, We have a team for software development, firmware development as well as CAD design.
we will define milestones and adjust the amount after discussion
Let me know if you need help from me.
Thanks.
--Alpesh