Circuit - Simulation using SimPowerSystems

Hello. I'm an electrical engineer. Please tell me about details (input and outputs) and version of the Matlab in which you works. We can discuss any details in the chat. Thanks.

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in SMPS, supplies design from few watts to KW range using Buck, Boost, Buck -boost, Push Pull and H-bridge inverters I am excellent in solar, wind, Micro grid, smart grid and IEEE bus systems development in MATLAB Simulink Design, PSPICE, PSIM ,MULTISIM and LTSpice , Proteus Simulations. I did many projects for MS and PhD thesis like grid connected solar, wind, wave energy grid connected systems using MPPT, Multi-level converters, hybrid systems development and D-STATCOMs, FACTS devices for power stability, quality and control electrical vehicles, inductor motors. I worked for vehicle design simulation for different applications. I use to design Solar with MPPT using buck, buck-boost topologies, Power quality and control using Active filters, Opamp based circuit, digital circuits etc. I understand your requirement and ready to work for you. Please contact me for further discussion.

My Whatsapp: +92 321 6624970 I am an Electrical Engineer having specialization in Electronics and Control, teaching at Electrical Department FAST National University Pakistan. I am also persuing my MS degree in Electrical Engineering with specialization in CONTROL. I have taught the followings courses, and also done many projects related to these subjects as well as related to consumer electronics products. 1. Control System Design & Modelling (Continuous, Discrete, Linear, Non-Linear, Optimal, Fuzzy Logic + Matlab & Simulink) 2. Digital System/Logic Design (Verilog, VHDL, Logisim) 3. Digital Signal Processing (MATLAB) 4. Micro-controllers (8051, Arduino, PIC) 5. Power Electronics (PSIM, MATLAB, PSpice) 6. Control of Electric Machine Drives 7. Circuit Analysis and Designe etc 8. PCB Design (Proteous + Ultiboard + Altium Designer) I assure you, if you assign your project to me, you surely gonna work with me in future. Note: I also provide the services in Mechanical Engineering Projects.

Hi.! I can help you with that I have good experience in matlab simulink , and I can assure you that if you work with me once you will hire me again for this type of projects

Hi, I am an electrical engineer and expert in power systems and circuit analysis. I have done many projects in MATLAB simulink. I assure you I will complete the project according to your requirements. Thanks

Dear Sir, I have completed 12 projects in electronics /electrical using simulation and coding using SimPowerSystems and similar simulation software like Labview and CST.I do not take short term assignments. thanks and regards

Hi Etechlancer, I am competitive to this kind of task, can take good care of this project. In fact, I already done related to this job before. Let me know the best of your time so we can discuss further based on your requirements and we can move forward to the next step. Thanks, Joseph C Ocero

i completed my pcb design course with schematic diagram,reverse engineering process in orcad pspice.etc...

Hello! I'm sure if you hire me I will handle it quite well. I have 3 years of experience with that toolbox. I've acquired knowledge with undergraduate research in a laboratory where Power Electronic is highly used to make devices for renewable energy applications. If you hire me, you will not regret it. Thanks! Have a nice day!