Circut Design and Prototype - Pressure Sensor LED Readout

I require a circuit design and prototype for a medical device that will convert hand grip pressure on a cylindrical object constructed of medical grade silicone to a LED Readout. The LED 5-bar readout will have red red amber amber green indicator of handgrip pressure on the cylindrical silicone bar. The bar readouts will indicate levels of pressure from soft (bottom red) to firm (green) Actuation of the sensor/readout will occur on application of pressure. De-activation will occur ~60 seconds after last activity. The power source will be a button battery. The construct must use smallest possible components. The sensor must operate being encased in Medical Grade Silicone. As it is a medical device, the sensor must be able to tolerate (in off state) 140 degrees Celcius in an Autoclave. The LED readout and power and MCU circuit will be detatchable to avoid autoclave. The force range would be 0 - 100kpa, and the sensor preferably must be cylindrical and measure lateral forces on the cylinder of med grade silicone. This will be used to measure grip strength of infants. Smaller is better. The sensor should read approx 0 - 100KPa. A sensor range need to be indicated due to dampening of the force due to the Silicone. That is - the grip strength will be 0 - 100kpa, but I need to be able to interchange the sensor to accommodate the dampening effect of the Silicone till I get an appreciable reading. The other way that this could be acheived is calibrating the MCU to account for the loss of sensitivity or having an adjustable sensitivity. The bid will include 1 Comprehensive Circiut Design and component list with specs, 2 Working Prototype (not including silicone encasement) 3 Posting the prototype to Canberra Australia - Address to be supplied to winning bid.