Buck converter design with multisim

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in SMPS, supplies design from few watts to KW range using Buck, Boost, Buck -boost, Push Pull and H-bridge inverters I am excellent in solar, wind, Micro grid, smart grid and IEEE bus systems development in MATLAB Simulink Design, PSPICE, PSIM ,MULTISIM and LTSpice , Proteus Simulations. I did many projects for MS and PhD thesis like grid connected solar, wind, wave energy grid connected systems using MPPT, Multi-level converters, hybrid systems development and D-STATCOMs, FACTS devices for power stability, quality and control. I use to design Solar with MPPT using buck, buck-boost topologies, Power quality and control using Active filters, Opamp based circuit, digital circuits etc. I understand your requirement and ready to work for you. Please contact me for further discussion.

I can do your job . I have 4 years experience in embedded and analog design .. so I can do your job within a time limit with your satisfaction.

I am an electronics engineer and responsible for power management on the research projects of space and defense. I have designed many power management units.

I have worked on national instruments multisim software ago. I have also simulated buck converter using matlab. As you have not attached any designed document I cannot exacty say what i will have to do and how much time I will require. I will have to download and install it again...